The Raspberry Pi takes 5 volts to run, and you can connect it directly to the GPIO (general purpose input/output)—the 26 pins next to the yellow video out socket (shown above).

Set up and configure your Pi If you have just bought your Raspberry Pi, this command is one of the first tools you’ll use to set it up. To use it, open the terminal and run 'sudo raspi-config ...

There’s currently a significant amount of confusion around the full extent of the GPIO hardware issue in the Raspberry Pi RP2350 microcontroller, with [Ian] over at [Dangerous Prototypes] of … ...

Posted in Raspberry Pi Tagged gpio, power supply, RPi ← Open Source Brushless Motor Controller Homebrew 68k Extravaganza → ...

GPIO programming on a Raspberry Pi using Arduino's Web IDE - this post brings Raspberry Pi and Arduino together.

One of the biggest draws of the Raspberry Pi family of single board computers or SBCs is their expandability. That comes via the standard 40-pin GPIO header on the full-sized boards.

With Opto-pi, there is not an electrical connection between the Raspberry Pi and connected loads (motors, relay coils, etc.) or input signals. Opto-pi uses light to isolate the 8 digital GPIO pins.

Raspberry Pi enthusiasts looking for a quick way to add GPIO pins for prototyping that can be then easily removed once the project is finalised, are sure to be interested in a new PCB quick clip ...

Externally, the Raspberry Pi 5 looks like its predecessors. The size of the board is unchanged, as is the 40-pin GPIO strip. The USB ports and the network socket have been swapped compared to ...

The Raspberry Pi team is back with a new small-but-mighty computer, the Raspberry Pi 5, with updated components and better specifications.